Chapter 3: Installing The Modem - ADC 400F User Manual

The Megabit Modem 400F is easy to install:
•
attaching adhesive-backed feet
• setting the MDI/MDI-X switch
• connecting a cable from the modem to a PC or an Ethernet hub for LAN service
•
connecting a phone cord from the modem to a wall phone jack for DMT ADSL Internet
or other types of WAN services
• connecting a power cable to a local power outlet
Perform the installation on the following pages (see
page 6 to determine where to place modems). Use the parts listed below in the installation
procedures.
Part
Rubber feet (four)
Black cable
Grey phone cord
Power cable
Grey cable and
adapter
Megabit Modem 400F User Manual
I
NSTALLING THE
Function
Installation Kit
Attaches to the base of the modem.
Connects the modem 10/100BASE-T connector to the LAN through a hub
or to a PC NIC.
Connects the modem ADSL connector to the RJ-11 wall jack with DMT
ADSL service for access to the Internet or other types of WAN applcations.
Connects the modem POWER connector to the local power source. Power
supply optionally has a power cord. (See
selection options.)
Not In Installation Kit (in ship box)
Connects the RS-232 MGMT port to an ASCII terminal or a PC running
terminal emulation software. Adapter assembly connects to a DB-9
connector on the PC. Then, one RJ-45 connector installs in the adapter and
the other connector into the console port on the modem.
M
ODEM
"Location for Modem Installation" on
"Power Cable" on page 10
3
for
11