Troubleshooting - ADC 400F User Manual

Troubleshooting

T
ROUBLESHOOTING
If this occurs: Try this:
PC or hub not • Check the LINK LED. If it is off, check the cabling to the 10/100BASE port and to the hub
communicating
or the NIC card in the PC to ensure it is secure.
with the modem
• Check the position of the MDI/MDI-X switch. Set the switch to MDI when connecting to
a PC. Set the switch to MDI-X when connecting to a hub or router.
• Check that you are using a Web browser (Netscape or Internet Explorer) version 4.0
or newer.
• Check that you have a TCP/IP protocol stack installed on your PC.
• If this is the initial installation, check that you set the IP address on your PC to obtain an
IP address automatically. Make sure you have configured the LAN IP address of the
modem to an address that is on the correct subnet. See
the Modem" on page
• You configured the LAN IP address of the modem to an address that is not on the
same subnet.
• Check the NIC card installation for correct IRQ, drivers, and adapter setup. See
appropriate documentation for the NIC card.
If none of the above corrects your problem, contact your service provider.
SYNC ADSL LED Contact the service provider when the LED remains off indicating that the modem is not
detecting a transceiver at the far end. Flashing green indicates that the modem is attempting
to bring up the link. Solid green indicates that the loop is up.
The modem synchronizes at a minimum transmission rate of 64Kbps. The modem rate
adapts in increments of 32Kbps.
MARGIN ADSL Contact the service provider when the LED is off indicating that the margin is below that
LED lights green specified by the service provider.
LAN TX and RX Check that the LINK LED is on. If it is on, you are simply not transmitting or receiving data
LEDs are not on on the LAN 10/100BASE-T port. If, however, the LINK LED is not on, check the section
or hub not communicating with the modem"
ADSL TX and RX Check that the SYNC LED is on. If it is on, you are simply not transmitting or receiving data
LEDs are not on on the WAN ADSL port. If, however, the SYNC LED is not on, contact your service provider.
60
18.
in this table.
"Setting Up the PC To Configure
Megabit Modem 400F User Manual
"PC