ADC 400F User Manual page 50

Configuring RFC 1483 Bridging/Routing Sessions
4 Enter the LAN configuration parameters.
‹
Select Enable
MAC addresses, as indicated by the service provider (see
Œ
Assign a port priority when you enable
EasySession
session to determine which has higher priority when there are sessions active
simultaneously. Spanning Tree protocol does not allow loops which would
occur with simultaneous sessions on the same network. See the configuration on
page 84

Select
Enable
IP addresses, as indicated by the service provider (see
42
to use Bridging mode which forwards Ethernet data based on
page). The port priority is a number you assign to each
for whether or not
Spanning Tree
to use mode which forwards IP datagrams based on
Routing
page
mode and
Bridging Spanning Tree
is enabled.
page 84).
Megabit Modem 400F User Manual
84).
(on the
mode
Bridging
‹
Œ

Ž


‘
’
“
”
•