Selecting A Configuration Model - ADC 400F User Manual

Selecting a Configuration Model

S
ELECTING A
There are many configuration options for the Megabit Modem 400F from which you can select.
The following is a recommended model for configuring the Megabit Modem 400F:
1 Complete the WAN configuration on
2 On the EasySession page:
Select the sessions you want active then click Enable. The modem will set up the session
with the service provider. The
session was successfully set up.
3 Set up the LAN side configuration, including DHCP on
1483. The modem will serve IP addresses to devices on the LAN (routing mode only).
36
C
ONFIGURATION
page 38
radio button next to the session(s) will indicate that the
Up
M
ODEL
for Bridge/Router RFC 1483.
page 41 for Bridge/Router RFC
Megabit Modem 400F User Manual