Chapter 8 Compliance With Each Region; Compliance With Ce Marking; Ce Marking; For Compliance - Mitsubishi Electric Melservo-Jet HG-SNS Series User Manual

8
COMPLIANCE WITH EACH REGION
8.1

Compliance with CE marking

CE marking

The CE marking is mandatory and must be affixed to specific products placed on the European Union. When a product
conforms to the requirements, the CE marking must be affixed to the product. CE marking also incorporates the machines and
equipments that are for sale with the servo motors in the European Union area. Each manual is available in different
languages. For details, refer to our website or contact our local sales office.
EMC directive
The EMC directive applies to the rotary servo motor alone. Therefore, the rotary servo motor is designed to comply with the
EMC directive. The EMC directive also applies to machines and equipment incorporating rotary servo motors. HG-KNS and
HG-SNS series comply with EN61800-3 Category 3. These series are not intended to be used on a low-voltage public
network which supplies domestic premises; When used on such network, radio frequency interference may occur. The
installer must provide a guide for installation and use, including the recommended mitigation devices.
Low voltage directive
The low voltage directive also applies to the rotary servo motor alone. The rotary servo motor is designed to comply with the
low voltage directive.
Machinery directive
The rotary servo motor as a single unit does not comply with the Machinery directive due to correspondence with Article 1.2
(k). However, the Machinery directive applies to machines and equipment incorporating rotary servo motors. Please check if
the machines and equipment as a whole are in conformity.

For compliance

Be sure to perform an appearance inspection of every unit before installation. In addition, have a final performance inspection
on the entire machine, and keep the inspection record.
Wiring
Use wiring which complies with EN for the rotary servo motor power. Products in compliance with EN are available as options.
For options, refer to the following.
Page 35 WIRING OPTION
Performing EMC tests
When EMC tests are run on a machine and equipment into which the servo amplifier and rotary servo motor have been
installed, it must conform to the electromagnetic compatibility (immunity/emission) standards after it has satisfied the
operating environment and electrical equipment specifications. For EMC directive conforming methods about servo amplifiers
and rotary servo motors, refer to "EMC Installation Guidelines".
8 COMPLIANCE WITH EACH REGION
90
8.1 Compliance with CE marking