Receiving - YASKAWA MECHATROLINK-II SI-T3 Technical Manual

3 Receiving

3 Receiving
Please perform the following tasks after receiving the MECHATROLINK-II Option:
• Inspect the MECHATROLINK-II Option for damage.
If the MECHATROLINK-II Option appears damaged upon receipt, contact the shipper immediately.
• Verify receipt of the correct model by checking the information on the PCB (see
• If you have received the wrong model or the MECHATROLINK-II Option does not function properly, contact your
supplier.
Contents and Packaging
Description: Option Card
SI-T3
Quantity:
Tool Requirements
A Phillips screwdriver (#2 (M3)) U.S. standard size is required to install the MECHATROLINK-II Option.
8
Table 1 Contents of Package
Ground Cable
1 1
YASKAWA ELECTRIC SIEP C730600 50A YASKAWA AC Drive-Option Card MECHATROLINK-II Technical Manual
Figure
Screws (M3) LED Label
ERR
RX
3
1).
Installation Manual
MANUAL
RUN
TX
1 1