Sun Microsystems SPARCserver 1000 System Installation Manual page 28

2
2-8
4. At the ok prompt, type:
ok probe-scsi-all
The OpenBoot probe-scsi-all command checks all available SCSI
devices on the host SCSI bus. Watch the monitor and verify that it displays
the newly-added SCSI tray disk drives.
Note – If the SPARCserver 1000 system does not recognize one or more disk
drives (new or old), contact your service representative.
5. When the system displays the ok prompt, type:
ok boot -r
When the system finishes booting, it displays the login prompt
(hostname%). At this point, log in and continue operation.
SPARCserver 1000 System Disk Drive Installation Manual—July 1995