oventrop Regtronic RQ Installation And Operating Instructions For The Specialised Installer page 9

Values and adjustments can be changed in different
ways:
adjusted value
(not yet confi rmed)
adjustment channel
minimum value current value saved
Numeric values can be adjusted by means of a slide
bar. The minimum value is indicated to the left, the
maximum value to the right. The large number above
the slide bar indicates the current adjustment. By
pressing buttons ❷ or ❹ the upper slide bar can be
moved to the left or to the right.
Only after the adjustment has been confi rmed by
pressing button ➄ will the number below the slide
bar indicate the new value. The new value will be
saved if it is confi rmed by pressing button ➄ again.
The display jumps back to the former menu level.
minimum
value
inactive area
When two values are locked against each other, they
will display a reduced adjustment range depending on
the adjustment of the respective other value.
In this case, the active area of the slide bar is short-
ened, the inactive area is indicated as a dotted line.
maximum value
The indication of the minimum and maximum values
will adapt to the reduction.
If only one item of several can be selected, they will
be indicated with "radio buttons". When one item
has been selected, the radio button in front of it is
fi lled. The selection will be saved if it is confi rmed by
pressing button ➄ again. The display jumps back to
the former menu level.
maximum
value
Some menu items are indicated with chackboxes.
active area
When an item has been selected, an x appears inside
the checkbox.
9