oventrop Regtronic RQ Installation And Operating Instructions For The Specialised Installer page 33

Note:
The controller will only recognise a firm-
ware update file if it is stored in a folder
named "OVENTROP / RQB" on the first
level of the SD card.
ÎCreate a folder named "OVENTROP /
RQB" on the SD card and extract the
downloaded ZIP file into this folder.
Starting the logging
Î Insert the SD card into the slot
Î Adjust the desired logging type and interval
Logging will start immediately.
Stopping the logging
Î Select the menu item Remove card...
Î After Remove card is displayed, remove the
card from the slot
When Linear is adjusted in the Logging type ad-
justment channel, data logging will stop if the capac-
ity limit is reached. The message Card full will be
displayed.
If Cyclic is adjusted, the oldest data logged onto the
SD card will be overwritten as soon as the capacity
limit is reached.
Note:
Because of the increasing size of the data
packets, the remaining logging time does not
decrease linearly. The data packet size can
increase, e. g. with the increasing operating
hours value.
Storing controller adjustments
Î To store the controller adjustments on an SD
card, select the menu item Save adjustments.
While the adjustments are being stored, first Please
wait, then Done! will be indicated on the display.
The controller adjustments are stored as a .SET file
on the SD card.
Loading controller adjustments
Î To load controller adjustments from an SD card,
select the menu item Load adjustments.
The File selection window is indicated.
Î Select the desired .SET file.
While the adjustments are being loaded, first Please
wait, then Done! will be indicated on the display.
SD card
Adjustment channel Description
Remove card... Safely remove card
Save adjustments Save adjustments
Load adjustments Load adjustments
Logging interval Logging interval
Logging type Logging type
Format card Format card
Formatting the SD card
Î Select the menu item Format card
The content of the card will be deleted and the card
will be formatted with the FAT file system.
Note:
To remove the SD card, always select the
menu item Remove card... before remov-
ing the card.
Adjustment range / selection Factory setting
-
-
-
00:05 ... 20:00 (mm:ss)
Cyclic, Linear
-
-
-
-
01:00
Linear
-
33