Adjustments; Main Menu; Status Menu; Meas. / Balance Values - oventrop Regtronic RQ Installation And Operating Instructions For The Specialised Installer

3

Adjustments

3.1

Main menu

In this menu, the different menu areas can be se-
lected.
The following menus are available:
Status
Hot water
Circulation
Afterheating
Disinfection
Additional functions
Basic setting
SD card
Manual mode
User code
Inputs
Note:
If no button is pressed for the adjustable
time T -display standby (see page 32),
the display illumination goes out. After 3
more minutes, the controller switches to
the Status menu.
Î In order to get from the Status / Hot
water menu into the Main menu, press
button ➆.
3.2

Status menu

In the Status menu of the controller, the status mes-
sages for every menu area can be found.

3.2.1 Meas. / Balance values

In the Status / Meas. / Balance values menu, all
current measurement values as well as a range of
balance values are displayed. Some of the menu items
can be selected in order to enter a sub-menu.
All measured values for the main and additional func-
tions, the allocation of sensors and relays as well as
the operating hours counter are displayed.
If, for example, Hot water is selected, a sub-menu
with the sensors and relays allocated to the system
will open. In the sub-menu, the current temperatures
and the current pump speed are indicated.
When a line with a measurement value is selected,
another sub-menu will open.
If, for example, VFD is selected, a sub-menu indicat-
ing the minimum and maximum values will open.
When the item Chart is selected, a progression
chart appears.
The progression chart shows the development at the
corresponding sensor over the last 24 hours. Press
buttons ❷ and ❹ to switch back and forth between
a chart of the current day and one of the day before.
15