Glueing Cab Windows - Valtra 6000 Workshop Manual

80. Cab and shields

2. Glueing cab windows

The cab front windows and the door windows have been
fastened with sealing compound (butyl) and plastic fas-
teners. In connection with possible repair work the windows
are fitted as follows:
1. Clean the window contact surfaces from remaining seal-
ant and glass. Remove possible grease spots with suitable
solvent.
2. Before fastening the window, check that it fits into place.
Ensure that there are not unevenesses on the contact sur-
face (e.g. welding splashes etc).
3. Place butyl rubber band KH 3708 onto the window con-
tact surface on the door or on the cab frame.
4. Position the window in place and fasten it with the plastic
fasteners. Check that the glass is in the middle of the open-
ing.
5. Varnish the butyl band with protective lacquer UF 3274
so that dust does not fasten on the sealant (not necessary if
the tractor is not used in dusty conditions immediately after
fitting the windows).
Note! Since in very warm conditions the side exhaust pipe
can raise windscreen temperature near the max. allowable
temperature of the butyl band (+80˚C), the butyl band raw
material has been changed. Temperature resistance of the
new material is +100˚C. In addition, the side movement of
the windscreen has been prevented by filling the space
between the windscreen upper part and the frame with sili-
cone mass.
Order numbers:
--- Butyl band (Ø 8 mm, 6 m, 80˚C)
--- Butyl band (Ø 10 mm, 6 m, 100˚C)
--- Silicone (300 ml) . . . . . . . . . . . . . . . . . . . .
--- Silicone (80 ml) . . . . . . . . . . . . . . . . . . . . .
--- Cleaner (250 ml) . . . . . . . . . . . . . . . . . . . .
. . . . . . KH3708
. . . . KH6343
UK0067
UK0068
32637300
1133
Model
1. 1. 1995
6000-- 8750
1. 8. 1998
3. Changing rear window
1. Remove the damaged rear window. Remove the middle
position locking device by removing the latch, latch pin and
the spring (these parts were removed with effect from trac-
tor ser. no. 658670).
2. Check that the handle fits correctly against the window.
Bend the handle, if needed, so that holes on the handle
and the window are against each other. Check also that the
handle fastening flanges are parallel with the glass surface.
Fasten the handle and note the mounting order of the
fastening parts.
3. Fit the window seal. Fit the window. Bend the hinges, if
necessary, so that the window fits correctly in position.
4. Adjust counter piece 31607100 so that the glass closes
with power of 15 kp which corresponds the seal compres-
sion of 2---4 mm in the middle of the seal in the lower edge.
If there is not enough adjusting space, new M6 holes have
to be drilled for counter piece screws HD 9153. Alternatively
sheet iron screws HN 6646 can be used.
Code Page
811 3