Valtra 6000 Workshop Manual page 1337

101. Special tools
44.2 Mechanical reverse shuttle
A
ETV 892 180 Drift for fitting needle bearing/sealing ring inside the reverse shuttle input shaft in transmission 300 and 460.
These parts only on tractors without the quick ---shift gear or the DPS.
ETV 894 200 Drift for fitting needle bearing/sealing ring inside the reverse shuttle input shaft in transmission 650
(8450---8750). These parts only on tractors without the DPS gear.
ETV 892 180
44.3 4WD clutch/4WD output shaft
A
1
ETV 893 260 ) Socket spanner for 4WD output shaft nut (Gearbox 505 ---905)
2
ETV 894 170 ) Socket spanner for 4WD output shaft nut (new tool)
1
ETV 891 900 ) Sleeve for fitting 4WD output shaft sealing ring/bearing (Gearbox 505---905)
B
1
ETV 890 830 ) Sleeve for fitting 4WD clutch piston onto the output shaft (PTO 505 ---905)
1
) Tractors without quick ---shift gear or with 2 ---step quick ---shift gear
2
) Tractors with 3---step quick ---shift gear Delta Powershift. The nut is the same as the nut at the front end of the bevel pinon shaft
on 505---905 tractors. For this nut spanner ETV 893 440 is used. Spanner ETV 894 170 can be replaced by welding a sleeve onto
the tool ETV 893 440.
ETV 893 260
ETV 894 170
ETV 894 200
15. 5. 1996
1. 10. 1999
ETV 891900
1280
Model Code
101
6000-- 8750
ETV 890 830
Page
6