Troubleshooting Phs-12 To Phs-14, Phs-24 To Phs-26 - Agilent Technologies Medalist i3070 5i Series Manual

If the sensor responds
1 Trigger the sensor again and check if the PLC responds (check the PLC
2 If the PLC does not respond, perform a continuity check on the PLC's
3 If the continuity check fails, check the cables and connectors.

Troubleshooting PHS-12 to PHS-14, PHS-24 to PHS-26

See
PHS-12
PHS-14
PHS-13
PHS-25
PHS-24
PHS-26
See
Figure 6-
Check the sensor response
• Manually trigger the sensor and see whether it responds.
Figure 6-3
6-12
I/O indicator).
If the PLC responds, it was likely an intermittent failure and no further
action is needed.
connector signal terminals.
Figure 6- 5 on page 6- 17 for the location of the sensors.
Presser Upper Limit Sensor
Presser Home Sensor
Presser Lower Limit Sensor
Conveyor Right Limit Sensor
Conveyor Origin Sensor
Conveyor Left Limit Sensor
Figure 6- 5 for the location of the sensors; also see
8.
Board Sensor
Red – Sensor is triggered
Troubleshooting
Figure 6- 7 and
i3070 Series 5i Help