Agilent Technologies Medalist i3070 5i Series Manual page 50

Table 3-5
Calibration Option
75mm Jig Long Probe Pos
Position where the board is in contact with
the long probes only, for dual stage testing.
75mm Board Align Pos
Standby position while verifying that the
board is seated properly on the tooling pin
and support plate.
6 When finished, press Next to check the taught positions using the
Complete the Setup
1 Turn the Maintenance Key Switch to OFF.
2 Close all the doors and covers.
3 Press the Reset button.
4 On the LCD touch panel Main page, select Production.
3-24
Press Positions
Presser Go Position pages.
Press a button and verify that the Press moves to the taught position.
Press Position
Test Development
i3070 Series 5i Help