Agilent Technologies Medalist i3070 5i Series Manual page 30

Figure 3-2 Board Specifications
Minimum clearance
3.0 mm (0.12 in)
Width
Board Width
Minimum: 60.0 mm (2.36 in)
Maximum: 350.0 mm (13.8 in) without top side
and dual stage probes
Tolerance: 0.25 mm (0.01 in)
PCB
3-4
Free Area at Board Edges
•
No probing allowed in this area.
•
Components must not be located in
or lean into this area.
PCB
Length
Top Side Components
Maximum: 90.0 mm (3.54 in)
Bottom Side Components
Maximum: 30 mm (1.18 in)
Tooling Pins
Tooling pin bushing must not be located
in or lean into free area of board edge
Tooling Holes
•
Use diagonally opposing holes
•
Diameter:
2.54 to 4.45 mm (0.100 to 0.175 in)
Recommended 3.175 mm (0.125 in)
Minimum clearance
3.0 mm (0.12")
Board Length
Minimum: 50.0 mm (2.36 in)
Maximum: 350.0 mm (13.8 in) without top side
and dual stage probes
Nominal Board Thickness
Minimum: 0.60 mm (0.023 in)
Maximum: 4.00 mm (0.157 in)
Test Development
i3070 Series 5i Help