Agilent Technologies Medalist i3070 5i Series Manual page 42

Adjust Conveyor Width
The conveyor width can be adjusted using the hand crank or via the LCD
touch panel.
Using the Crank
1 Open the controller pod and Zone 2 doors. Remove the testhead pod
2 On the manual control panel, turn the Maintenance Key Switch to ON.
3 Insert the crank into the leadscrew. Turn the crank to adjust the
3-16
Ensure the Maintenance Key Switch is set to ON when adjusting
CAUTION
the conveyor.
cover.
conveyor to the required width.
Place a production board on the conveyor and ensure that the board
can be transported smoothly from Zone 1 to Zone 2.
Maintenance Key Switch
Reset Button
Test Development
i3070 Series 5i Help