Chapter 3 How to Login the Switch
3.1 Switch to End Node
Use standard Cat5/5e Ethernet cable (UTP/STP) to connect the switch to end nodes as
described below. Switch ports will automatically adjust to the characteristics (MDI/MDI-X,
speed, duplex) of the device to which they are connected.
The LNK/ACT/Speed LEDs for each port light when the link is available.
3.2 How to Login the Switch
As the switch provides Web-based management login, you can configure your computer's
IP address manually to log on to the switch. The default settings of the switch are shown
below.
Parameter
Default IP address
Default Username
Default Password
You can log on to the configuration window of the switch through following steps:
1.
Connect the switch with the computer NIC interface.
2.
Power on the switch.
3.
Check whether the IP address of the computer is within this network segment:
192.168.2.xxx ("xxx" range is 2-254); for example, 192.168.2.100.
4.
Open the browser, and enter http://192.168.2.1 and then press "Enter." The switch
login window appears, as shown below.
Figure 7 - PC Connect
Default Value
192.168.2.1
admin
admin
11
Web-Managed Gigabit Ethernet Switch