Chapter 3 - How To Log Into The Switch; Switch To End Node; Login Information - Intellinet 560559 User Manual

Chapter 3 - How to Log into the Switch

3.1 Switch to End Node

Use standard Cat5 and higher Ethernet cable (UTP/STP) to connect the Switch to
end nodes as described below. Switch ports will automatically adjust to the
characteristics (MDI/MDI-X, speed, duplex) of the device to which is connected.
Please refer to the LED Indicator
each port lights when the link is available.

3.2 Login Information

As the Switch provides Web-based management login, configure your computer's IP
address manually to log onto the Switch. The default settings of the Switch are
shown below.
Parameter
Default IP address
Default Username
Default Password
You can log into the configuration window of the Switch through following steps:
Connect the Switch with the computer NIC interface.
1.
Power on the Switch.
2.
Web Smart Managed PoE Switches User Manual
table shown above. The LNK/ACT/Speed LEDs for
Default Value
192.168.2.1
admin
SERIAL NUMBER (S/N; found on
the bottom of the switch)
13