Intellinet 560917 User Manual page 50

Web-Managed Gigabit Ethernet Switch
Policy Name: Displays the policy to which the class map is being added.
Class Name: Select an existing class map to be associated with the policy. Class maps
are created on the Class Mapping page.
Action Type: Select the action regarding the ingress CoS/802.1p and/or DSCP value of
all the matching packets.
Police Type: Available in Layer 2 system mode only. Select the policer type for the policy.
Aggregate Policer: Available in Layer 2 system mode only. If Police Type is Aggregate,
select a previously defined (in the Aggregate Policer page) aggregate policer.
Ingress Committed Information Rate (CIR): Enter the CIR in kbps. See a description of
this on the Bandwidth page.
Ingress Committed Burst Size (CBS): Enter the CBS in bytes. See a description of this
on the Bandwidth page.
Exceed Action: Select the action assigned to incoming packets exceeding the CIR.
4.7.3.6 Policy Binding
The Policy Binding page shows which policy profile is bound and to which port. When a
policy profile is bound to a specific port, it is active on that port. Only one policy profile can
be configured on a single port, but a single policy can be bound to more than one port.
When a policy is bound to a port, it filters and applies QoS to ingress traffic that belongs to
the flows defined in the policy. The policy does not apply to traffic egress to the same port.
To edit a policy, it must first be removed (unbound) from all those ports to which it is
bound.
To display the Policy Binding page, click QoS > QoS Advanced Mode > Policy Binding.
49