Take-Up With The Printed Side Facing Out - Epson SureColor SC-S70600 series Operator's Manual

EPSON SC-S70600 series/SC-S50600 series
F
Push the holder until part A shown in the
illustration below is fully inserted, and tighten
the screw.
c
Important:
Stop when part A is no longer visible. The
take-up reel unit may not function as
expected if the holder is inserted too far.
For the subsequent steps, see the following
depending on how the media is rolled.
For information on taking-up with printed side
out, see U "Take-up with the Printed Side
Facing Out" on page
For information on taking-up with printed side
in, see U "Take-up with the Printed Side Facing
In" on page 20.
Operator's Guide
Basic Operations
17.
Take-up with the Printed Side
Facing Out
A
Cut the paper tape approximately 60 cm in
length, and paste it approximately in the center of
the media using commercially available adhesive
tape.
B
Hold down the u button until the tip of the tape
reaches the center of the pipe.
C
Turn the paper tape over from the front of the roll
core, and stick using commercially available
adhesive tape.
17