Adjusting The Needle Bar Height - DURKOPP ADLER D867 M-Type Delta Service Instructions Manual

8.3 Adjusting the needle bar height

Order
First, check the following settings:
Disturbance
Disturbances caused by an incorrect needle bar height:
Fig. 41: Adjusting the needle bar height
(1) - Needle bar
Proper setting
The hook tip is level with the lower third of the groove on the needle.
To adjust the needle bar height:
1. Execute the service routine Needle-Hook > Timing ( p. 14).
 The software is used to define the necessary presettings on
56
• Looping stroke position ( p. 52)
• Damage to the hook tip
• Jamming of the needle thread
• Skip stitches
• Thread breaking
• Needle breakage
the machine.
Position of the hook and needle
①
②
(2) - Screw
Service Instructions M-TYPE DELTA - 00.0 - 12/2019
1/3