DURKOPP ADLER D867 M-Type Delta Service Instructions Manual page 83

Thread trimmer (FA)
Adjusting the end position of the knife
11. Loosen the clamping screw (8).
Fig. 66: Adjusting the cutoff curve (2)
(10) - Screw
(11) - Counter blade
(12) - Thread-pulling knife
(13) - End position marking
12. Turn the thread-pulling knife (12) so that the marking indicating the
13. Tighten the clamping screw (8) on the lever (7) such that the lever (7)
14. Loosen the threaded pins (3).
15. Push the set collar (2) to the right as far as it will go and against
16. Check the looping stroke position ( p. 52).
17. Tighten the threaded pins (3).
Service Instructions M-TYPE DELTA - 00.0 - 12/2019
⑩
⑪
⑫
⑬
end position (13) is exactly next to the tip of the counter blade (11).
has no axial play.
the control cam (4).
(14) - Screw
(15) - Hook thread clamp
(16) - Screw
⑯
⑮
⑭
81