DURKOPP ADLER D867 M-Type Delta Service Instructions Manual page 156

Each input can be switched to Latching or Hold to run.
Output Configuration
Configure and allocate the outputs here. The table shows the outputs and
their allocation. The pins on the PCB are labeled and must be allocated
according to the table, depending on what was connected to the pin.
Each output can be assigned one of the following modes.
154
• Program selection Bit B7
• Program selection Bit B8
• Program selection Bit B9
• Short stitch
nd
• 2 edge guide position (height)
nd
• 2 edge guide position (gap and height)
• DB3000
• DB2000
• Function module 1
• Function module 2
• Function module 3
• Function module 4
• Function module 5
• Function module 6
• Function module 7
• Function module 8
• Sewing light
• Machine head lighting
• Sewing foot lift
nd
• 2 position sewing foot lift
• Sewing foot lift
• Needle thread tension
• Thread trimmer
• Needle cooling
• NSB knife
• NSB block
• Pos. 1
• Pos. 2
Service Instructions M-TYPE DELTA - 00.0 - 12/2019
Programming