DURKOPP ADLER D867 M-Type Delta Service Instructions Manual page 210

1007
1008
1010
1011
1012
1054
1055
1060
1061
1120
1121
1203
1302
1330
2101
2105
2121
2122
208
Code Type Meaning
Error Error in the reference run
Error Sewing motor encoder error
Error External synchronizer plug
(Sub-D, 9-pin) not connected
Error Encoder Z pulse missing
Error Synchronizer fault
Error Internal short circuit
Error Sewing motor overload
Error Sewing motor overload / overvoltage /
overcurrent
Error Sewing motor overload / overvoltage /
overcurrent
Error Sewing motor Init fault
Error Sewing motor watchdog
Error Position not reached (during thread
cutting, reversal, etc.)
Error Failure with sewing motor current
Error No response from sewing motor
Error Stepper motor X30 reference run
timeout
Error Stepper motor card X30 blockage
Error Stepper motor card X30 encoder plug
(Sub-D, 9-pin) not connected
Error Stepper motor card X30 flywheel
position not found
Remedial action
• Replace encoder
• Check for stiff movement
• Replace encoder
• Connect cable of external
synchronizer to control, make sure
that interface (Sync) is correct
• Only recommended for machines
with transmission!
• Switch off the control, use
handwheel to turn, and switch on
the control again
• If error is not corrected, check
encoder
• Replace synchronizer
• Replace control
• Check for stiff movement
• Replace encoder
• Replace sewing motor
• Check selection of class
• Replace control
• Replace motor
• Replace encoder
• Check selection of class
• Replace control
• Replace motor
• Replace encoder
• Perform a software update
• Check selection of class
• Perform a software update
• Check selection of class
• Check the controller settings and
change them if necessary
(e.g. thread trimmer setting, belt
tension, etc.)
• Check position thread lever at top
dead center
• Check Service Stop
• Check for stiff movement
• Replace encoder
• Replace motor
• Perform a software update
• Replace control
• Check reference sensor
• Check for stiff movement
• Connect encoder cable to the
control, use the correct interface
• Check stepper motor 1 for stiff
movement
Service Instructions M-TYPE DELTA - 00.0 - 12/2019
Troubleshooting