Aligning The Needle Bar Linkage In The Sewing Direction - DURKOPP ADLER D867 M-Type Delta Service Instructions Manual

Adjusting feed dog and needle bar linkage

7.4 Aligning the needle bar linkage in the sewing direction

Fig. 35: Aligning the needle bar linkage in the sewing direction
(1) - Screw
Proper setting
If the stitch length is 0, the needle pierces exactly in the center of the
needle hole.
To align the needle bar linkage in the sewing direction:
1. Switch off the machine.
2. Disassemble the front cover ( p. 20).
3. Switch on the machine.
4. Execute the service routine Needle-Hook > Needle bar ( p. 14).
 The software is used to define the necessary presettings on the
5. Loosen the screw (1).
6. Move the needle bar linkage such that the distance between presser
7. Tighten the screw (1).
8. Finish the service routine.
Service Instructions M-TYPE DELTA - 00.0 - 12/2019
10 mm
machine.
bar and walking foot bar is 10 mm.
①
49