Transfer Configuration To The Mbnet - MB Connect Line mbNET Series Quick Start Up Manual

7.1.4 Transfer confi guration to the mbNET
When the mbNET is ready to operate, insert the USB stick into the USB port of the device.
As soon the mbNET recognizes the confi guration
fi le, both LED Fc1 + LED Fc2 are fl ashing�
Press immediately and hold down the Dial Out
button

until LED Fc3 fl ashes
Release the Dial Out button
The settings from mbCONNECT24 are now
automatically copied to the mbNET and the device
reboots�
If the mbNET is able to connect to the Internet
(e.g. network, telephone cable, SIM card, antennae
installed), the device will subsequently log in to your
account�
This is displayed by the fl ashing LED Con �
If the fl ashing frequency of the LED Con is 3 Hz, the device is attempting to log into the portal.
If the login has been successful, the fl ashing frequency is reduced to 1.5 Hz.
�

�

- 16 -
Fc1 Fc2
Fc3 Fc4
Fc1
Fc3
Rdy Con
Rdy
Pwr Err
Pwr

Dial Out
WAN WAN
Fc2 Fc2
Fc1

Fc3 Fc4 Fc4
Rdy Con
LAN1
Pwr Err

LAN3
LAN3
Dial Out
USB
Dial Out
Reset
Fc1 Fc2
Fc3 Fc4 Fc4

Rdy Con Co
Pwr Err
Fc2
Fc4
Con
Err
COM1
1
LAN2
2
3
LAN4
4
COM2