Transfer Configuration To The Mbnet.mini - MB Connect Line mbNET.mini Series Quick Start Up Manual

Transfer configuration to the mbNET.mini

When the mbNET.mini is ready to operate, insert the USB stick
into the USB port of the device.
The device will recognize the configuration file and show that th-
rough the slowly flashing LED Usr (flashing frequency: 1.5 Hz).
As soon as the LED Usr starts to flash
you must press the Function button within
10 seconds.
Hold down until the LED Usr lights.
Now release the Function button
When the LED Usr goes off and the LED Pwr
+ Rdy light up, then the configuration transfer
is complete.
When the mbNET.mini can connect to the Internet
(e.g. network cable, SIM card, antennae installed),
the device will subsequently log in to your account.
This is displayed by the flashing LED Con.
If the flashing frequency of the LED Con is 3 Hz, the device is attempting to log into the portal. If
the login has been successful, the flashing frequency is reduced to 1.5 Hz.
12
,

.

Pwr
Rdy
Con
Usr

Pwr
Rdy
Con
 Usr
Pwr
Rdy
Con
Usr
Pwr
Rdy
Con
Usr