MB Connect Line mbNET Series Quick Start Up Manual page 10

Hide thumbs Also See for mbNET Series:
Table of Contents

Advertisement

Label
Status
LED off
Pwr
(Power)
LED on
LED flashing
Rdy
(Ready)
LED on
LED off
Fc1
(Function 1)
LED on
LED off
Fc2
(Function 2)
LED flashing Serial interface COM1 sending data.
LED off
Fc3
(Function 3)
LED flashing
LED off
Fc4
(Function 4)
LED flashing
LED off
LED on
Con
LED flashing
(Connect)
(1,5Hz)
LED flashing
(3 Hz)
Router power source is switched off or router is not connected to
power source / power pack.
Power source is connected to terminal block and switched on.
The Ready LED does this for approx. 35 seconds when the de-
vice is switched on. After this, flashing indicates boot sequence.
This may take up to 90 seconds depending on the type of device.
The router is ready.
Serial interface COM1 not receiving data.
Serial interface COM1 receiving data.
Serial interface COM1 not sending data.
Serial interface COM2 not receiving data.
Serial interface COM2 receiving data.
On if MPI: bus communication OK.
Serial interface COM2 not sending data.
Serial interface COM2 sending data.
If MPI: bus transferring data.
No connection to Internet or VPN.
Connection to Internet.
VPN connection active.
Internet or VPN connection is being established.
- 10 -
Description

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the mbNET Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents