9.1.6 Transfer configuration to the mbNET
When the mbNET is ready to operate, insert the USB stick into the USB port of the device.
As soon the mbNET recognizes the configuration
file, both LED Fc1 + LED Fc2 are flashing.
Now press and hold down the Dial Out button
until LED Fc3 flashes
Release the Dial Out button
The settings from mbCONNECT24 are now
automatically copied to the mbNET and the device
reboots.
If the mbNET is able to connect to the Internet
(e.g. network, telephone cable, SIM card, antenna
installed), the device will subsequently log in to your
account.
This is displayed by the flashing LED Con .
If the flashing frequency of the LED Con is 3 Hz, the device is attempting to log into the portal.
If the login has been successful, the flashing frequency is reduced to 1.5 Hz.
.
.
- 22 -
Fc1
Fc2
Fc3
Fc4
Rdy
Con
Pwr
Dial Out
Fc2
Fc1
Fc3
Fc4
Rdy
Con
Pwr
Dial Out
Fc1
Fc2
Fc3
Fc4
Rdy
Con
Pwr
Fc1
Fc2
Fc3
Fc4
Rdy
Con
Pwr
COM1
WAN
1
LAN1
LAN2
2
3
LAN4
LAN3
4
USB
COM2
Dial Out
Reset