3M MATIC A80F Instructions And Parts List page 37

10-SAFETY DEVICES OF THE MACHINE
10.1 Blade Guards
Both the top and bottom taping units have a blade
guard. (See Manual 2: AccuGlide™ 2+ STD 2 Inch
Taping Heads).
WARNING
•
To reduce the risk associated with sharp
blade hazards:
−
Keep hands and fi ngers away from tape
cutoff blades under orange blade guards.
The blades are extremely sharp.
10.2 Emergency Stop Button
The box drive belts are turned on and off with the
electrical switch on the side of the machine frame.
The machine electrical supply can be turned off
by pressing the latching emergency stop switch.
To restart machine, rotate the emergency stop
switch clockwise to release the switch latch.
Restart machine by turning the On/Off switch to
the Off (O) position and then to the On (I) position
(Figure 10-1) .
WARNING
•
To reduce the risk associated with
pinches, entanglement and hazardous
voltage:
−
Turn electrical supply off and disconnect
before performing any adjustments,
maintenance or servicing the machine or
taping heads.
WARNING
•
To reduce the risk associated with
hazardous voltage:
−
Position electrical cord away from foot
and vehicle traffi c.
a80f-NA
Figure 10-1
10.3 Electric System
The electric system is protected by a ground wire
whose continuity has been tested during the fi nal
inspection. The system is also subject to insulation
and dielectric strength tests.
•
To reduce the risk associated with
mechanical and electrical hazards:
−
Allow only properly trained and qualifi ed
personnel to operate and service this
equipment.
Note: The case sealer has a circuit breaker
located in the electrical enclosure on the machine
frame. If circuit becomes overloaded and circuit
breaker trips, unplug the machine electrical
cord and determine cause of overload. After two
minutes, reset the circuit breaker by turning the
On/Off switch to the Off (O) position and then to
the On (I) position. Plug machine electrical cord
into outlet and restart machine by turning the
On/Off switch to the Off (O) position.
Important: The use of an extension cord is not
recommended. However, if one is needed for
temporary use, it must:
• Have a wire size of 1.5mm diameter [AWG16]
• Have a maximum length of 30.5m [100ft]
• Be properly grounded.
25
WARNING
2010 March