Space Requirements For Machine Operation And Maintenance; Tool Kit Supplied With The Machine; Machine Positioning - 3M MATIC A80F Instructions And Parts List

7-INSTALLATION
7.1 Operating Conditions
The machine should operate in a dry and relatively
clean environment at 5° to 50°C. with clean dry
boxes-relative humidity between 0% and 80%
7.2 Space Requirements for Machine Operation
and Maintenance Work
Minimum distance from wall (Figure 7-1):
A = 1.0m. (39.4 inches)
B = 0.7m. (27.6 inches)
Minimum height = 2.7m. (106.3 inches)
B
A
WARNING
•
To reduce the risk associated with
mechanical and electrical hazards:

Read, understand, and follow all safety and
operating instructions before operating or
servicing the case sealer.

7.3 Tool Kit Supplied with the Machine

A 17mm and 21mm open-end wrench and a
17mm hex socket wrench are provided with the
machine.
The following customer-supplied tools are
required for machine setup, maintenance, and
adjustments:
•
3mm hex wrench
•
4mm hex wrench
•
5mm hex wrench
•
6mm hex wrench
•
7mm combination wrench
•
8mm combination wrench
•
10mm combination wrench
•
13mm combination wrench
•
17mm combination wrench
•
#2 Phillips screwdriver
a80f-NA
Figure 7-1
18
7.4 Machine Positioning / Bed Height
WARNING
•
To reduce the risk associated with
muscle strain:
−
Use the appropriate rigging and material
handling equipment when lifting or
repositioning this equipment.
−
Use proper body mechanics when
removing or installing taping heads that are
moderately heavy or may be considered
awkward to lift.
1 - Lift the machine with belts or ropes paying atten-
tion to place the belts in the points (Figure 7-2).
To set the machine
bed height, do the
following:
2 - Adjust machine bed
height. The case
sealer is equipped
with four adjustable
legs. Using a 6mm
hex wrench, loosen
the socket head
screws that hold the
inner leg assem-
bly to the machine
as shown (Figure
7-3). Also refer to
the "Specifi cations"
section.
3 - Lock/tighten screws.
4 - Repeat the
operation adjusting
all legs equally.
(It is not necessary
to fi x or anchor the
machine to the fl oor).
Figure 7-2
Figure 7-3
2010 March