Configuring Network Speed And Duplex Mode - Yealink VC800 Administrator's Manual

Administrator's Guide for Yealink VC800 Video Conferencing System
A dialog box pops up to prompt that the settings will take effect after a reboot.
Click OK to reboot the phone.
5.
To configure IPv6 address assignment method via phone user interface:
Select More->Setting->Advanced (default password: 0000) ->Internet Configuration.
1.
Select IPv4 & IPv6 or IPv6 from the IP Mode field.
2.
Press or
3.
Select the desired IPv6 address assignment method.
4.
If you uncheck the DHCP checkbox, configure the IPv6 address and other network
parameters in the corresponding fields.
Select Save, and then press
7.
The IP phone reboots automatically to make settings effective after a period of time.
To configure static DNS when DHCP is used via phone user interface:
Select More->Setting->Advanced (default password: 0000) ->Internet
1.
Configuration->IPv6.
Check the DHCP checkbox.
2.
Check the Static DNS checkbox.
3.
Enter the desired values in the DNS Primary Server and DNS Secondary Server fields
4.
respectively.
Select Save, and then press
5.
The display device prompts "Reboot now?".
6.
Select OK, and then press
7.

Configuring Network Speed and Duplex Mode

You can configure the network speed and duplex mode the system uses. The network speed
and duplex mode you select for the system must be supported by the switch. The network
speeds and duplex modes supported by the system are:
Auto

10 Mbps Full Duplex

100 Mbps Full Duplex

10 Mbps Half Duplex

100 Mbps Half Duplex

1000 Mbps Full Duplex

Auto is configured on the system by default.
36
to highlight IPv6 and press
to accept the change.
to accept the change.
to reboot the system immediately.
.