30
:TIMebase Commands
:TIMebase:POSition
Command Syntax
:TIMebase:POSition <pos>
<pos> ::= time in seconds from the trigger to the display reference
The :TIMebase:POSition command sets the time interval between the trigger event
and the display reference point on the screen. The display reference point is either
left, right, or center and is set with the :TIMebase:REFerence command. The
maximum position value depends on the time/division settings.
This command is an alias for the :TIMebase:DELay command.
N OTE
Query Syntax
:TIMebase:POSition?
The :TIMebase:POSition? query returns the current time from the trigger to the
display reference in seconds.
Return Format
<pos><NL>
<pos> ::= time in seconds from the trigger to the display reference
See Also
•
•
•
•
•
•
1052
(see
page
1368)
in NR3 format
in NR3 format
"Introduction to :TIMebase Commands"
":TIMebase:REFerence"
":TIMebase:RANGe"
on page 1053
":TIMebase:SCALe"
on page 1057
":TIMebase:WINDow:POSition"
":TIMebase:DELay"
on page 1304
Keysight InfiniiVision M9241/42/43A PXIe Oscilloscopes SCPI Programmer's Guide
on page 1050
on page 1055
on page 1059