System:preset - Keysight Technologies InfiniiVision M9241A Scpi Programmer's Manual

29
:SYSTem Commands

:SYSTem:PRESet

Command Syntax
:SYSTem:PRESet
The :SYSTem:PRESet command places the instrument in a known state. This is the
same as pressing the [Default Setup] key or [Save/Recall] > Default/Erase > Default
Setup on the front panel.
When you perform a default setup, some user settings (like preferences) remain
unchanged. To reset all user settings to their factory defaults, use the *RST
command.
Reset conditions are:
Acquire Menu
Mode
Averaging
# Averages
Analog Channel Menu
Channel 1
Channel 2
Volts/division
Offset
Coupling
Probe attenuation
Vernier
Invert
BW limit
Impedance
Units
Skew
Cursor Menu
Source
1034
(see page 1368)
Keysight InfiniiVision M9241/42/43A PXIe Oscilloscopes SCPI Programmer's Guide
Normal
Off
8
On
Off
5.00 V
0.00
DC
10:1
Off
Off
Off
1 M Ohm (cannot be changed)
Volts
0
Channel 1