Table of Contents
Advertisement
3.4.4
Leakage test
Profipress G XL
Open the adapter jaw.
Position the adapter jaw into the seat of the press ring.
Carry out the pressing process.
Open the adapter jaw and remove the press ring.
Remove the checking strip.
ð The connection is marked as having been pressed.
The installer must perform a leakage test before commissioning.
This test is carried out on a system that is finished but not yet covered.
Observe the applicable regulations, see
Leakage test" on page 8 .
Document the result.
Ä „Regulations from section:
22 from 23
Handling
Advertisement
Table of Contents
