Setup - MULTIQUIP LD6 Operation Manual

BATTERY
CAUTION
Use all safety precautions specified by the battery
manufacturer when handling the battery. See the
Safety Information section of this manual for details
on battery safety.
1. Tilt the operator's seat forward (Figure 12) to access
the battery.
OPERATOR'S
SEAT
BATTERY
Figure 12. Battery Access
2. Make sure the battery is well secured in the battery
tray with the two battery bolts (Figure 13).
–
+
Figure 13. Battery Connection
3. Connect the positive (RED) battery cable to the
positive (+) terminal on the battery, then connect the
negative (BLACK) battery cable to the negative (–)
terminal. See Figure 13.
LD6 RIDE-ON POWER TROWEL • OPERATION MANUAL — REV. #0 (02/10/20) — PAGE 25
BATTERY
BOLT
FLOAT PAN INSTALLATION (OPTIONAL)
Float pans attach to the spider arms and allow early floating
on wet concrete and easy movement from wet to dry areas.
They are also very effective at embedding large aggregates
and surface hardeners.
WARNING
ALWAYS install float pans either in the work area or
in an area that is next to and level with the work area.
NEVER lift the trowel with float pans attached.
1. Make sure the blades are pitched completely flat
(no pitch).
2. Lift the trowel just enough to slide a float pan under the
blades. Lower the trowel onto the pan with the blades
adjacent to the Z-clips (Figure 14).
TIE-DOWN
KNOB
Z-CLIP, PAN
Figure 14. Float Pan Installation
3. Rotate the blades into position under the Z-clips. Make
sure the blades are rotated in the same direction as
when the machine is in operation, or use the engine
to rotate the blades into position.
4. Attach the blade tie-downs to the far side of the Z-clip
brackets with the tie-down knobs as shown in Figure 14.
5. Make sure the blade edges are secured under the
Z-clips and the tie-downs are secured completely over
the edges of the blade bar before the trowel is put back
into operation.

SETUP

BLADE
TIE-DOWN
BLADE
ASSEMBLY