MULTIQUIP LD6 Operation Manual page 29

4. Insert the ignition key into the ignition switch (Figure 21).
While keeping your foot off the foot switch, turn the
ignition key clockwise to the START position. Once
the engine starts, release the ignition key.
KEY
Figure 21. Ignition Key Switch (Start)
NOTICE
If the engine fails to start, consult the engine owner's
manual supplied with the trowel.
5. Let the engine idle for 2–3 minutes. Once the engine
has warmed, push the choke knob (Figure 19) inward
to the OPEN position.
6. Place the engine throttle lever in the FAST (rabbit)
position. See Figure 22.
ENGINE THROTTLE
LEVER (FAST)
Figure 22. Engine Throttle Lever (Fast)
LD6 RIDE-ON POWER TROWEL • OPERATION MANUAL — REV. #0 (02/10/20) — PAGE 29
OFF
ON
START
P/N 45650
TESTING THE SEAT SWITCH
Make sure the safety seat switch is operational prior to
using the trowel each day.
1. With the engine running, depress the foot switch to start
turning the rotors. Observe that the blades are rotating.
2. While keeping the foot switch depressed, rise from the
operator's seat.
3. Verify that the blades stop rotating while the engine
continues to run.
4. If blade rotation has stopped, the seat switch is working.
5. If blade rotation continues, the seat switch is not
working. Stop the engine immediately and correct the
problem.
WARNING
NEVER disable or disconnect the seat switch. It is
provided for operator safety. Injury may result if it is
disabled, disconnected or improperly maintained.
OPERATION