MULTIQUIP LD6 Operation Manual page 34

CAUTION
Certain maintenance operations or machine adjustments
require specialized knowledge and skill. Attempting to
perform maintenance or adjustments without the proper
knowledge, skills or training could result in equipment
damage or injury to personnel. When in doubt, consult
your dealer.
AIR CLEANER
The engine air cleaner assembly is equipped with a round
air cleaner cartridge and a foam pre-cleaner. Clean or
replace the air cleaner elements as necessary.
NOTICE
Operating the engine with loose or damaged air cleaner
components could allow unfiltered air into the engine,
causing premature wear and failure.
NOTICE
NEVER run the engine with the air cleaner removed.
1. Release the latches (Figure 29) on each side of the air
cleaner cover and remove the cover.
LATCHES
KNOB
CARTRIDGE
Figure 29. Air Filter Components
2. Remove the knob and the plate (Figure 29).
PAGE 34 — LD6 RIDE-ON POWER TROWEL • OPERATION MANUAL — REV. #0 (02/10/20)
AIR CLEANER
COVER
PLATE
FOAM
PRE-CLEANER
BODY
3. Remove the foam pre-cleaner and cartridge (Figure 29)
carefully to prevent dirt and debris from entering the
carburetor.
4. Inspect the pre-cleaner and cartridge. Replace the
cartridge if it is excessively dirty.
NOTICE
DO NOT use solvents or pressurized air to clean the
cartridge. Pressurized air can damage the cartridge,
and solvents will dissolve the cartridge.
5. Wash the foam pre-cleaner (Figure 30) in liquid
detergent and water and squeeze dry in a clean cloth.
Figure 30. Cleaning the Foam Pre-Cleaner
6. Assemble the clean (or new) foam pre-cleaner onto a
new cartridge.
7. Reinstall the new air cleaner assembly with the plate
and knob into the body.
8. Replace the air cleaner cover and secure with the
latches.
MAINTENANCE