Components (Trowel) - MULTIQUIP LD6 Operation Manual

35
27. Operator's Seat — Operator's seat tilts forward for
service access.
28. Heat Exchanger — Keeps hydraulic oil at the optimum
operating temperature.
29. Hydraulic Oil Reservoir — Visually inspect the level
of hydraulic oil in the reservoir. Remove the filler cap to
add hydraulic oil. Open only when the system is cool.
Reservoir capacity is 0.45 gallons (1.70 liters). Use
Parker DuraClean ISO 46 hydraulic oil only.
30. Steering Control Handles (2) — Located to the left
and right of the operator, these dual palm-grip joysticks
are linked to three hydraulic steering cylinders. Refer
to the Operation section to learn more about steering.
31. Lift Loops (2) — Attach lifting slings here to lift the
trowel. Refer to the Lifting and Transporting section
for more information.
32. Carbon Canister — A container filled with activated
charcoal traps gasoline vapor emitted by the fuel
system and releases it to the engine. Reduces
emissions and increases fuel efficiency.
LD6 RIDE-ON POWER TROWEL • OPERATION MANUAL — REV. #0 (02/10/20) — PAGE 23
27
30
31
28
37
36
Figure 10. LD6 Trowel Components (Cont.)

COMPONENTS (TROWEL)

30
31
29
32
33
33. Fuel Filler Cap — Remove the fuel filler cap to add
unleaded gasoline to the fuel tank. Use 87 or 89 octane
gasoline only.
34. Fuel Tank — Holds up to 4 gallons (15 liters) of
unleaded gasoline. Use 87 or 89 octane gasoline only.
35. Spider Assemblies (2) — Each spider assembly has
four trowel arms with 8-inch combination blades equally
spaced in a radial pattern.
36. Engine — Briggs & Stratton Vanguard 23-horsepower,
small block, V-twin, horizontal shaft, air-cooled, OHV,
gasoline engine. See the Engine Components section
for more details.
37. Hydraulic Filter — Filters hydraulic fluid as it enters
the system. Equipped with 10-micron, glass-filled filter
media.
34
35