MULTIQUIP LD6 Operation Manual page 36

4. Remove the oil drain plug (Figure 34) and allow the
oil to drain into a suitable container through the drain
hole in the engine mounting bracket.
OIL
DRAIN
HOLE
ENGINE
MOUNTING
BRACKET
Figure 34. Engine Oil Replacement
5. After the oil has fully drained, reinstall the oil drain plug.
6. Using a filter wrench (Figure 35), turn the oil filter
counterclockwise to remove.
Figure 35. Oil Filter Removal
7. Clean the sealing surface where the filter mounts onto
the engine.
PAGE 36 — LD6 RIDE-ON POWER TROWEL • OPERATION MANUAL — REV. #0 (02/10/20)
8. Coat the seal of the new oil filter (Figure 36) with clean
OIL
DRAIN
PLUG
9. Remove the oil filler cap and add 1 quart (32 oz./1 liter)
10. Start and run the engine at idle for 30 seconds.
11. Shut down the engine and wait 30 seconds. Then slowly
12. Replace the oil filler cap and make sure the dipstick
SPARK PLUGS
1. Make sure the engine is cool before servicing the
2. Loosen the spark plugs and remove any dirt from
3. Remove and inspect the spark plugs. Replace the
OIL FILTER
WRENCH
MAINTENANCE
engine oil. Install the new filter by hand until it contacts
the engine sealing surface, then tighten it another
1/2 to 3/4 turn. DO NOT use a strap wrench or similar
tool to tighten the filter.
RUBBER
SEAL
ENGINE OIL
FILTER
Figure 36. Oil Filter
of oil to the engine.
add more oil to bring the level up to the FULL mark
on the dipstick. Refer to Table 3 for engine oil capacity.
DO NOT overfill.
is fully inserted.
spark plugs.
around the spark plug area.
spark plugs if they are damaged, the sealing washer
is in poor condition, or the electrode is burned or worn.
OIL
COAT SEAL
WITH THIN
LAYER OF OIL