General Information - MULTIQUIP LD6 Operation Manual

INTENDED USE
Operate the LD6 ride-on power trowel, tools, and
components in accordance with the manufacturer's
instructions. Use of any other tools for stated operation is
considered contrary to designated use. The risk of such
use lies entirely with the user. The manufacturer cannot be
held liable for damages as a result of misuse.
SAFE OPERATION
Read all safety information carefully. Safety instructions
will be found throughout this manual and on the machine.
Keep all safety information in good, readable condition.
Operators should be well trained on the operation and
maintenance of the trowel.
FAMILIARIZATION
The LD6 is a ride-on power trowel designed for the floating
and finishing of concrete slabs.
Walk around the trowel and take note of the major
components—engine, blades, air cleaner, fuel system,
ignition switch, etc. Make sure there is always a proper
level of lubricating oil in the engine and a proper level of
hydraulic oil in the hydraulic oil reservoir.
Before using your trowel, test it on a flat, watered-down
section of finished concrete. This test run will familiarize you
with the trowel's controls and will increase your confidence
in operating the trowel. You will learn how the trowel handles
under actual operating conditions. Refer to the Operation
section of this manual for more information.
ENGINE
The LD6 is equipped with a Briggs & Stratton Vanguard
3864 gasoline engine. Refer to the engine owner's manual
for specific instructions regarding engine operation and
maintenance.
PAGE 20 — LD6 RIDE-ON POWER TROWEL • OPERATION MANUAL — REV. #0 (02/10/20)

GENERAL INFORMATION

BLADES
The blades of the LD6 finish concrete as they are rotated
across the surface. Blades are classified as combination
(10 or 8 inches wide) or finish (6 inches wide). The LD6
is equipped with four blades per rotor equally spaced in a
radial pattern and attached to a vertical rotating shaft by
means of a spider assembly.
OPTIMIZED HYDRAULIC SYSTEM
The spider assemblies are driven by two high-torque
hydraulic motors coupled to a variable displacement,
axial piston hydraulic pump for increased overall system
performance.
HYDRAULIC STEERING
Dual palm-grip joystick controls located to the left and right
of the operator are provided for steering. The joysticks are
linked to three hydraulic steering cylinders located within
the frame of the machine.
OPTIONS
Optional kits for retardant spray and lights are available.
Contact the Multiquip Parts Department for more
information.
TRAINING
For proper training, please use the Training Checklist
form located in the front of this manual. This checklist will
provide an outline for an experienced operator to provide
training to a new operator.