Table of Contents
Advertisement
Adjustment
Sowing wheel (accessory)
Lubricate and adjust wheel bearings at least once annually. Check tyre
pressures (see recommended pressure on tyre).
Adjustment and lubrication of wheel bearings
1. Remove hub caps.
2. Remove split pin.
3. Tighten castle nut 1/6th of a turn until hole aligns with axle. Turn wheel,
4. Replace split pin
5. Fill hub cap ¾ full with grease. Replace.
Scraper
Hydraulics
Check all hydraulic hoses for wear or cracks. Check all hoses for crimping.
Lubricate exposed rams with oil or pressure-resistant grease to avoid rust
forming when storing for long periods. Remember to remove before use.
Page 26
Maxiroll Greenline Lift
check for resistance. A little play should be detected in the hub housing
when rocking wheel from side to side. If play is excessive, repeat process.
Adjust scrapers as required, approx.
5-10 mm from roller.
1. Slacken bolts (A). Scraper
can be pushed closer to
roller.
2. Retighten bolts. Scraper
must not be in direct contact with
roller.
Fig. 22
Advertisement
Table of Contents
