Installing The Display Assembly - Dell Inspiron 16 Plus 7640 Owner's Manual

Figure 33. Display assembly
Steps
1. Disconnect the speaker cable from its connector (SPK2) on the system board.
2. Remove the speaker cable from its routing guides.
3. Remove the two screws (M2.5x5.5) that secure the left display assembly hinge to the system board.
4. Pry open the left-display assembly hinge at an angle of 90 degrees.
5. Peel the tape that secures the display-cable latch to its connector.
6. Lift the latch and disconnect the display-assembly cable from its connector (LCD1) on the system board.
7. Remove the two screws (M2.5x5.5) that secure the right-display assembly hinge to the system board.
8. Pry open the right-display assembly hinge at an angle of 90 degrees.
9. Lift the palm-rest and keyboard assembly at an angle off the display assembly.

Installing the display assembly

CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the display assembly and provides a visual representation of the installation
procedure.
60 Removing and installing Field Replaceable Units (FRUs)