Executing Firmware Updates For Cylinder - CEStronics OMEGA FLEX Manual

4 Executing firmware updates for Cylinder

4 Executing firmware updates for Cylinder

Required programming device: Programming Adaptor (Cylinder)
If you are updating a dual cylinder, you must update both knobs of the cylinder.
1. Connect the Programming Adaptor to your PC.
If you are connecting the programming adaptor for the first time to the PC, the driver will be
installed automatically now. You can then use the Programming Adaptor.
2. Dismantle the electronic knob of the cylinder which you want to update.
Dismantling the electronic knob
Dismantling electronic knob
Programming Adaptor
1. Loosen the K
NOB SLEEVE
by hand.
with the CES-S and
PANNER
If If the knob-sleeve cannot
be loosened by hand, you
may use CES K -
NOB SLEEVE
wrench to loosen it.
You can aquire the CES
Knob-sleeve wrench thorugh
your CES partner.
Use the CES knob-sleeve
wrench only on the stainless
steel sleeve, never on the
light ring.
Rotate the CES Knob-sleeve
wrench against the locking
directing while you place it
on or pull it off so as not to
scratch the knob-sleeve.
Page 9 of 30