CEStronics OMEGA FLEX Manual page 13

4 Executing firmware updates for Cylinder
Programming Adaptor
Make sure that the large spring lies over the
large groove and the small spring over the
small groove.
2. Insert the with correct polarity.
BATTERIES
Use only Panasonic CR2 Industrial Lithium 3,0 V
850 mAh batteries.
Make sure that the battery strap lies below the
battery and the end of the battery strap is
protruding out.
The correct polarity is indicated in the
module.
The electronics knob blinks once red and once red-
green.
3. Place the on the
KNOB SLEEVE
4. Tighten the K
NOB SLEEVE
by hand.
Do not use the CES knob-sleeve wrench to
tighten the knob sleeve. If you screw the knob
too tightly, you may damage the knob.
BATTERY
.
ELECTRONIC KNOB
with the CES-S and
PANNER
Page 13 of 30