CEStronics OMEGA FLEX Manual page 11

4 Executing firmware updates for Cylinder
4. Start the update program OMEGA Firmware Update.
Programming Adaptor
If you touch the knob electronic, it can be
damaged. Therefore, hold the knob electronics
only within the marked area:
2. Push the knob down and simultaneously turning
it clockwise. The knob thus engages in the
Programming Adaptor.
3. Insert the batteries in the knob.
Use only Panasonic CR2 Industrial Lithium 3,0 V
850 mAh batteries.
Make sure that the battery strap lies below the
battery and the end of the battery strap is
protruding out.
The correct polarity is indicated in the
module.
The knob is now connected to the Programming
Adaptor.
BATTERY
Page 11 of 30