CEStronics OMEGA FLEX Manual page 26

Page 26 of 30
6 Executing firmware update for Smart shield SIS
2. Insert the batteries with correct polarity
holder.
BATTERY
Use only Energizer Ultimate Lithium 1,5V AAA
batteries.
The correct polarity is indicated in the
module.
3. Make cable connection between e-module and
the bracket by plugging the cable into the
vertical cable connector.
Make sure that the cable plug is inserted the
right way around (see figure). Otherwise the
contacts may get damaged.
4. Put the SIS-S on the
HIELD
on the
FIXTURE RING LEVER HANDLE
5. Pull the tight
FIXTURE RING
spanner.
Do not over tighten the fixture ring, otherwise
the handle set may get damaged.
IN THE
BATTERY
and put the
BRACKET
.
CES ring
WITH THE
Programming Adaptor