3. Connect the electronic knob to the Programming Adaptor.
Connecting the electronic knob to the Programming Adaptor
Connecting the electronic knob to the Programming Adaptor
Page 10 of 30
4 Executing firmware updates for Cylinder
2. Remove the
KNOB SLEEVE
3. Remove the
.
KNOB
If you touch the knob electronic, it can be
damaged. Therefore, hold the knob electronics
only within the marked area:
This completes the knob dismantling.
1. Place the knob without battery on the
Programming Adaptor.
Make sure that the large spring lies over the
large groove and the small spring over the
small groove.
.
Programming Adaptor