CEStronics OMEGA FLEX Manual page 21

5 Executing firmware updates for Long shield ILS
Cable routing for Long shield bores
Cable routing for rosette bores
Cable routing for short shield bores
Assembly
Programming Adaptor
5. Guide the cables through the top elongated hole
of the .
MOUNTING PLATE
Pull the cables so far that they are not pinched
under the mounting plate.
5. Run the cables through the right rosette bore of
the .
ASSEMBLY PLATE
Pull the cables so far that they are not pinched
under the mounting plate.
5. Guide the cable through the recess in the bore for
the coupling follower in the
Make sure that the cables are located in the
groove on the back of the
Pull the cables so far that they are not pinched
under the mounting plate.
6. Assemble the handle set. The assembly differs
depending upon the type of hole the Long shield
ILS is attached to:
.
ASSEMBLY PLATE
plate.
ASSEMBLY
Page 21 of 30