Heat Settings; Remote Control Features - e-Flame USA EF-BLT13-36 Owner's Manual

CHARCOAL COLOR FIRE – Touch the button to turn the charcoal color fire effect on.
There are 10 options for charcoal color change. They are as follows:
• C1 – orange
• C2 – orange and green
• C3 – green
• C4 – green and blue
• C5 – blue
• C6 – blue and orange
• C7 – blue, orange and green
• C8 – blue and red
• C9 – red
• C10 – all colors on a loop

HEAT SETTINGS

This electric fireplace consists of a fan-forced electric heater with two heat settings:
• LO – 750-watts (press the button once to activate)
• HI – 1350-watts (press the button twice to activate)
This electric fireplace displays temperature two ways, Celsius (C) and Fahrenheit (F).
The unit defaults to Fahrenheit when turned on.
Note: the heater's fan will continue to run for a short time after turning unit off, and will
turn off automatically after the heater has cooled down.
TIMER
This fireplace is equipped with a timer ranging from 1-hour to 9-hours, and can be
programmed in 1-hour increments. Touch the button once for every 1-hour increment.
Do not leave the electric fireplace unattended.

REMOTE CONTROL FEATURES

Install the CR025 3V battery (included) into the remote control before
use. The master switch must be turned to "I" to operate the remote
control. Almost all the functions are the same as on the control panel
as previously listed above, however the No.1 and No.2 lock button are
for the charcoal fire. You can press the NO.2 button to lock any
changing color during display. F0 will display a loop. To choose any
charcoal fire you like during display press C0.
9